Pangolin Forum  

Go Back   Pangolin Forum > Hardware > QM2000 series of products

Thread Tools Display Modes
Old 10-27-2011, 01:09 PM
Guest Guest is offline
Join Date: Oct 2011
Posts: 22
Default Outdoor Venues


I just have a question as to any connectivity issues when doing a show at an outdoor venue. In different building I have required a change in IP address in order for the QM to connect to the laptop. If there any issue I would like to find them out, or possible troubleshooting ideas.

Thanks Again,

(novice laser show designer)
Reply With Quote
Old 12-30-2011, 07:22 AM
Cyberb0b's Avatar
Cyberb0b Cyberb0b is offline
Very helpful member
Join Date: Oct 2008
Location: Netherlands, Purmerend
Posts: 132

I dont understand the question completely, but did you check the application
"c: \ld2000\Network\QM2000NET_Config.exe" to configure the

If this application does not allow you to change the IP address of the, i think you need to contact pangolin.

Make sure your pc is in the same ip range as the controller currently is configured before changing the ip address.

Also, you can find a network scan utility on
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 05:47 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
© 2003-2016 Pangolin Laser Systems